|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-31-2017, 02:02 PM | #1 |
Member
Join Date: Jul 2010
Location: East L.A.
Posts: 39
|
Front spring id
The long and short of this story is this:
I purchased a front and rear suspension that were parted out of a 1940 slantback sedan- However the measurments on front spring are throwing me off - Eye to eye center is 38 1/2, leaves are 2" wide. There are 11 leaves including the saftey leaf. The spring had also had a grease sleave . What has me stumped is The eye diameter is 1 1/8", not 3/4- The center to center measurments on the spring hangers are 42 1/2" I still have the axle and the center to center perch bolt measurement is 38 1/2" The rest of the parts including the car were defiantly 1940... Unfortunately I no longer have the wishbone to confirm any measurments- At this point I'm trying to figure out what parts I actually have?? I'm using this spring in the ass end of my 29 roadster project.. II can post a picture of the spring later - Thanks in advance for the sharing of your early ford wisdom! Sent from my SM-G930T using Tapatalk Last edited by mullskull; 07-31-2017 at 02:43 PM. Reason: Misinformation |
|
|
Sponsored Links (Register now to hide all advertisements) |
|