04-03-2013, 03:16 AM | #1 |
Senior Member
Join Date: Jul 2011
Location: lawrenceburg, tn
Posts: 128
|
Frame sag
I've looked through a few post on frame sag & how to fix it etc but is the frame supposed to be completely flat on top from the very back to the front until the point where the frame horns start dropping down?
|
04-03-2013, 04:21 AM | #2 |
Senior Member
Join Date: Feb 2011
Location: Cocoa, Florida
Posts: 1,609
|
Re: Frame sag
Yes, and this shows it.... That was a question I had a while ago also.
__________________
Wanted: Simmons Super Power Head Craig Likon 1931 150B |
Sponsored Links (Register now to hide all advertisements) |
|
04-03-2013, 09:46 AM | #3 |
Senior Member
Join Date: Feb 2011
Location: De Pere, WI
Posts: 290
|
Re: Frame sag
Are the dimensions the same for a 30/31 chassis or is there a 30/31 diagram?
|
04-03-2013, 11:09 AM | #4 |
Senior Member
Join Date: May 2010
Posts: 1,261
|
Re: Frame sag
I must say that is the best illustration I have seen of a frame.
I too, wonder if there are any like it except for the '30 and the '31 assuming these two are different. Thanks for your time. Joe Grobleski |
04-03-2013, 02:40 PM | #5 |
Senior Member
Join Date: Feb 2011
Location: Cocoa, Florida
Posts: 1,609
|
Re: Frame sag
I seem to recall that Steve Plucker did quite a bit of research and may have at least descriptions in some of his PDF's on his website. Check it out.....
http://www.plucks329s.org/
__________________
Wanted: Simmons Super Power Head Craig Likon 1931 150B |
04-03-2013, 02:49 PM | #6 | |
Senior Member
Join Date: Jan 2011
Location: Pell City AL
Posts: 720
|
Re: Frame sag
Sponsored Links (Register now to hide all advertisements)
Quote:
Would be nice if there was a page or sticky page that helpful drawings and files could be store on the ford barn. I'm sure at some point, I will go back and search to find this drawing again. It's very helpful.
__________________
Jamie Crosson 1929 Tudor Looking for an Original 888 Key |
|
04-03-2013, 03:58 PM | #7 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Frame sag
That's where the thread title wording is very important. Giving it a title like "Frame Dimensions Picture" would be much better than just calling it "Frame" or " A Good Picture" or "I have a Question".
|
04-03-2013, 04:07 PM | #8 |
Senior Member
Join Date: Feb 2011
Location: Cocoa, Florida
Posts: 1,609
|
Re: Frame sag
Anything and everything that i find might be useful I save onto my computer in a series of files that make it easy to find. For example
Model A Electrical Distributor
__________________
Wanted: Simmons Super Power Head Craig Likon 1931 150B |
04-04-2013, 03:40 PM | #9 |
Senior Member
Join Date: Feb 2011
Location: Cocoa, Florida
Posts: 1,609
|
Re: Frame sag
Here is a 31 frame.
__________________
Wanted: Simmons Super Power Head Craig Likon 1931 150B |
|
|
Sponsored Links (Register now to hide all advertisements) |
|