|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-12-2018, 11:30 AM | #1 |
Senior Member
Join Date: May 2010
Location: Stratham, NH
Posts: 233
|
Installing Drake Running Board Covers
Have a pair of covers for 35/36 running boards which I bought from a friend.
However, there are no directions. Can someone who has a copy send them to me? My email is [email protected]. Thanks, Peter |
08-12-2018, 02:34 PM | #2 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 10,935
|
Re: Installing Drake Running Board Covers
Peter: Read through all the info. on GOOGLE and you will be a happy camper.
https://www.google.com/search?q=how+...hrome&ie=UTF-8 A Fordbarn search will give you info. also. https://www.fordbarn.com/forum/searc...rchid=10937037 and https://www.fordbarn.com/forum/showt...4308&showall=1 When you install the covers be sure not to pull or stretch them as you want them to lay down in an unstressed state. I first applied Contact cement to only the lipped edge of the running board and cover. Then I laid the remaining dry cover down on the dry board to check alignment and fit. Then I applied Contact cement in about 6 inches wide strips on both the running board and cover and brought them together. I did it this way to avoid having contact cement running all over the place and having to try and hold a big floppy cover. I used a Bondo spreader on the board and a brush on the cover. You could also used a small paint roller for more even results. That was 40 years ago and they are still holding fine. If you literally do a "dry run" first you will gain confidence. Last edited by 19Fordy; 08-12-2018 at 02:57 PM. |
Sponsored Links (Register now to hide all advertisements) |
|
08-12-2018, 10:16 PM | #3 |
Senior Member
Join Date: May 2010
Location: Tinley Park Ill
Posts: 1,060
|
Re: Installing Drake Running Board Covers
19 Fordy is correct. But you also need two more helpers and a bout six large clamps
|
08-13-2018, 01:01 PM | #4 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 10,935
|
Re: Installing Drake Running Board Covers
Thanks but, I installed my covers by my little old self. Be patient. Be careful.
|
08-13-2018, 01:29 PM | #5 |
Senior Member
Join Date: Feb 2013
Location: Eureka Calif.
Posts: 968
|
Re: Installing Drake Running Board Covers
Make sure that the running boards are straight. Believe it or not, dents will show through.
|
08-13-2018, 03:44 PM | #6 |
Senior Member
Join Date: May 2010
Location: southeastern Michigan
Posts: 10,101
|
Re: Installing Drake Running Board Covers
Sponsored Links (Register now to hide all advertisements)
Me too, several times. The only difference that I would recommend would be to progress in 3" increments rather than 6" increments, especially starting from the outer curved portion.. |
08-13-2018, 04:14 PM | #7 |
Senior Member
Join Date: May 2010
Location: Stratham, NH
Posts: 233
|
Re: Installing Drake Running Board Covers
Thanks for all your input.
Peter |
|
|
Sponsored Links (Register now to hide all advertisements) |
|