|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-04-2021, 12:52 PM | #1 |
Member
Join Date: Jul 2020
Location: Bonney Lake Washington
Posts: 50
|
Trim between upper and lower fender on a 41 Merc
I need to replace the welting on the stainless trim between the upper and lower front fenders on my 41 Merc. I can't not find this trim or replacement welting to slide back in. What has others done to install the trim between the front fenders? Thanks Rick
Last edited by Rick Leavitt; 05-04-2021 at 01:42 PM. |
05-04-2021, 02:30 PM | #2 |
Senior Member
Join Date: May 2010
Location: East Hartford, Ct
Posts: 5,898
|
Re: Trim between upper and lower fender on a 41 Merc
If you are talking about 3/16" dia stainless fender welting, Dennis Carpenter has it, as well as other vendors.
YOU have to cut, fit and form to fit.
__________________
DON'T RECALL DOING SOMETHING FOR MYSELF BASED ON SOMEONE ELSE'S LIKES OR DISLIKES |
Sponsored Links (Register now to hide all advertisements) |
|
05-04-2021, 06:24 PM | #3 |
Senior Member
Join Date: May 2010
Location: Charlotte NC KiWi-L100 available here
Posts: 2,963
|
Re: Trim between upper and lower fender on a 41 Merc
I believe this is 41 Mercury only trim. There is also early 41 & late 41 Mercury trim just like the park lights. Early was die cast. Late was stainless.
|
05-05-2021, 09:01 PM | #4 |
Member
Join Date: Jul 2020
Location: Bonney Lake Washington
Posts: 50
|
Re: Trim between upper and lower fender on a 41 Merc
This is different than the stainless fender welting. This is actually trim that the welting slides into and sandwiches in between the upper and lower fenders. I tried to upload a photo but my goofy butt can't figure out how to do it.
|
05-05-2021, 09:09 PM | #5 |
Member
Join Date: Jul 2020
Location: Bonney Lake Washington
Posts: 50
|
Re: Trim between upper and lower fender on a 41 Merc
This is different than the stainless fender welting. This is actually trim that the welting slides into and sandwiches in between the upper and lower fenders. I tried to upload a photo but my goofy butt can't figure out how to do it.
Last edited by Rick Leavitt; 05-05-2021 at 09:15 PM. |
05-05-2021, 10:16 PM | #6 |
Senior Member
Join Date: May 2012
Location: Queensland, Australia
Posts: 10,372
|
Re: Trim between upper and lower fender on a 41 Merc
Sponsored Links (Register now to hide all advertisements)
1941 Mercury Town Sedan |
05-10-2021, 12:22 PM | #7 |
Member
Join Date: Jul 2020
Location: Bonney Lake Washington
Posts: 50
|
Re: Trim between upper and lower fender on a 41 Merc
Beautiful
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|