|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-26-2015, 05:02 PM | #1 |
Senior Member
Join Date: Sep 2013
Location: Pemberville, Ohio
Posts: 456
|
How to install windshield frame gasket?
1930 fordor...
1. What are you supposed to do about the nut on each side that goes between the gasket and the frame? Seems there is not room for both. The only options seems to be to force it in and distort the gasket. Or should I stop the gasket short of the screw/nut? 2. How do I finish the corners? Cut each at a 45 degree angle? Then attempt to glue them? Leave them alone? Last edited by freak; 04-26-2015 at 05:15 PM. |
04-27-2015, 01:16 AM | #2 |
Senior Member
Join Date: Dec 2010
Location: Verdi, Nevada
Posts: 166
|
Re: How to install windshield frame gasket?
Leave corners alone, no glue....Trim rubber as necessary to fit behind the nut and framing metal... Sharp knife, screwdriver and good scissors and take your time.....
|
Sponsored Links (Register now to hide all advertisements) |
|
04-27-2015, 05:49 AM | #3 |
Senior Member
Join Date: Sep 2013
Location: Pemberville, Ohio
Posts: 456
|
Re: How to install windshield frame gasket?
cut the corners at 45 or 90?
|
04-27-2015, 05:57 AM | #4 |
Senior Member
Join Date: Sep 2011
Location: Luck WI
Posts: 550
|
Re: How to install windshield frame gasket?
Do not cut to fit right away, let it sit for a day or two before any final trimming as the rubber will be stretched from install and will shrink. I cut mine as a 45, because I like the look,
__________________
Jon "If you choose to not decide, you still have made a choice!" RUSH Don't tell me what you know..... Tell me what you have done. |
04-27-2015, 06:40 AM | #5 |
BANNED
Join Date: May 2010
Location: Bucks County, PA
Posts: 11,454
|
Re: How to install windshield frame gasket?
cut the corners to follow the wshld frame.. 45
|
04-28-2015, 05:35 PM | #6 |
Senior Member
Join Date: Sep 2013
Location: Pemberville, Ohio
Posts: 456
|
Re: How to install windshield frame gasket?
Sponsored Links (Register now to hide all advertisements)
|
04-28-2015, 07:25 PM | #7 |
Senior Member
Join Date: May 2010
Location: Lakeville, MN
Posts: 5,164
|
Re: How to install windshield frame gasket?
The corners look much better if you carefully cut them to 45 degrees after a few day to let the rubber settle and glue them together. I super glued my corners and they look very nice.
Rusty Nelson |
|
|
Sponsored Links (Register now to hide all advertisements) |
|