|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-03-2014, 06:16 PM | #1 |
Member
Join Date: May 2010
Location: Melbourne Australia
Posts: 39
|
REAR END Question
Hello everyone , maybe someone can give me some advice-
I have just replaced the diff carrier bearings (both bearings and cups). I have also replaced the carrier spider gears to eiminate the excessive axle end play. I have not replaced the crown gear/ring gear and the pinion adjustment was not touched. I made a note of the gaskets that were between the axle housing and banjo on each side when they were taken apart. My Question is - Do I need to reset any preloads or can I just bolt everything back together and all should be o.k. ? Tom Endy maybe able to chime in here . Thanks Mark. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|