|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-01-1970, 12:00 AM | #1 |
Guest
Posts: n/a
|
'27-'27 roadster windshield
I'm trying to restore an old rodded roadster to original, and want to know what type windshield was original. I've seen some with a two piece split and some one piece that were a little shorter that the two piece. Any info is appreciated. <table><tr><td><font face="arial"> |
01-01-1970, 12:00 AM | #2 |
Guest
Posts: n/a
|
Re: '27-'27 roadster windshield
I believe the two piece split is correct. <table><tr><td><font face="arial"> |
Sponsored Links (Register now to hide all advertisements) |
|
01-01-1970, 12:00 AM | #3 |
Guest
Posts: n/a
|
Re: '27-'27 roadster windshield
Thanks for the reply. I wonder where the one piece windshields came from? <table><tr><td><font face="arial"> |
01-01-1970, 12:00 AM | #4 |
Guest
Posts: n/a
|
Re: '27-'27 roadster windshield
It probably came from a hot rod shop. Wolf !! <table><tr><td><font face="arial"> |
01-01-1970, 12:00 AM | #5 |
Guest
Posts: n/a
|
Re: '27-'27 roadster windshield
I bought a rusty one via ebay. It has the wiper fitting, the push/pull handle at the bottom, rubber seal grove for the cowl, and swivels match the T stanchons. It matches the curvature of the cowl. I've conviced myself it is from Ford. I'd appreciate any info or comments. I'll supply any measurements needed. We can communicate via email if desired and I'll post any results here for general information. <table><tr><td><font face="arial"> |
01-01-1970, 12:00 AM | #6 |
Guest
Posts: n/a
|
Re: '27-'27 roadster windshield
Sponsored Links (Register now to hide all advertisements)
The one piece is a hot rod windshield for chopped top or no tops. Runnig with the top down and the winshield closed causes too much wind on the back of your neck. And side wind. If you block the top half open about 1 1/2 inches it drasticly reduces wind eddies on you. Makes much more pleasant driving at higher (35-65 mph) speeds. <table><tr><td><font face="arial"> |
01-01-1970, 12:00 AM | #7 |
Guest
Posts: n/a
|
Re: '27-'27 roadster windshield
The one piece is a hot rod windshield for chopped top or no tops. Runnig with the top down and the winshield closed causes too much wind on the back of your neck. And side wind. If you block the top half open about 1 1/2 inches it drasticly reduces wind eddies on you. Makes much more pleasant driving at higher (35-65 mph) speeds. <table><tr><td><font face="arial"> |
01-01-1970, 12:00 AM | #8 |
Guest
Posts: n/a
|
Re: '27-'27 roadster windshield
I am in need of the bottom most pasenger side clamp to hold the top 1/2 of the split windshield on my 27. Any one have one the would like to sell to me? Mick <table><tr><td><font face="arial"> |
|
|
Sponsored Links (Register now to hide all advertisements) |
|