|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-11-2010, 08:11 AM | #1 |
Junior Member
Join Date: Aug 2010
Location: Grand Rapids, Michigan, USA
Posts: 5
|
Rear Hub bearing and outer race replacement
When you order a replacement rear wheel bearing and outer race,
what is the loctite adhesive for? |
08-11-2010, 11:21 AM | #2 |
Senior Member
Join Date: May 2010
Location: Santee, California
Posts: 3,505
|
Re: Rear Hub bearing and outer race replacement
Thinking that you are referring to the repair race and bearing that goes into the rear hub, the locktite is used to lock the new race into the hub. The instructions say to press the new race into the hub with a film of the loctite in the old hub and on the new race. On my hubs, I was able to push them in by hand. No press needed. The new races would be spinning in the old if it were not for the loctite.
I'm concerned that you use the term "Replacement". If your race in your hub is good, you should not be using the "Repair" setup. |
Sponsored Links (Register now to hide all advertisements) |
|
08-11-2010, 11:29 AM | #3 |
Junior Member
Join Date: Aug 2010
Location: Grand Rapids, Michigan, USA
Posts: 5
|
Re: Rear Hub bearing and outer race replacement
thanks Russ,
so basically, I i must press the race into the hub, I probably won't need the loctite? the parts catalog call it a repair kit, but I think the dimensions of the replacement race are same as original. It's for pitted and worn bearing surfaces. |
08-11-2010, 11:40 AM | #4 |
Senior Member
Join Date: May 2010
Location: Oregon
Posts: 5,961
|
Re: Rear Hub bearing and outer race replacement
The replacement race uses the smaller OD V-8 bearing. Use the locktight. The race made to rework the axle housing surface can be used with either bearing.
|
08-11-2010, 01:26 PM | #5 |
Junior Member
Join Date: Aug 2010
Location: Grand Rapids, Michigan, USA
Posts: 5
|
Re: Rear Hub bearing and outer race replacement
thanks, J Franklin,
will do |
08-12-2010, 11:51 AM | #6 | |
Senior Member
Join Date: May 2010
Location: Santee, California
Posts: 3,505
|
Re: Rear Hub bearing and outer race replacement
Sponsored Links (Register now to hide all advertisements)
Quote:
Use the loctite! |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|