|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
09-22-2018, 10:24 AM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Jordan, MN
Posts: 1,411
|
Help: Removing swedged weights on Model B crankshaft
I need to remove the swedged weights from two Model B crankshafts prior to sending them to the crank grinder. Anyone have the set-up info to drill out the dowels? I saw a diagram some time ago that refrenced the angle of the dowel to the centerline of the main bearings.
Thanks in advance for any help provided. See the photos below.... Last edited by Dave in MN; 09-22-2018 at 10:32 AM. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:56 PM.