|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-13-2023, 10:27 PM | #1 |
Senior Member
Join Date: Aug 2012
Location: Texas
Posts: 225
|
fitting in side of block
I discovered a weird fitting in the side of my block. It appears to be where an oil pressure gage would have been connected. I think this is where the 1/8 pipe fitting plug should be. I tried to post a pic, but do not know how on this forum.
|
04-13-2023, 10:53 PM | #2 |
Senior Member
Join Date: Apr 2015
Location: Boise, Idaho
Posts: 1,578
|
Re: fitting in side of block
Sponsored Links (Register now to hide all advertisements)
There is also a tool that fits here for holding the oil pump in place if you remove the pan. And, if there were an oil pressure gauge fitted, it would also have used this port as a pressure source. Hope this helps! .
__________________
Early '29 CCPU that had a 4-speed, but not any more.......in the family since '62 |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|