|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-29-2019, 11:58 PM | #1 |
Senior Member
Join Date: Nov 2012
Location: Montrose,CO
Posts: 226
|
Grease Fitting thread size....
Which thread is used on the fitting to lube u-joint clamshell...
I want to make a remote grease line up to it ..I put a half tube of John Deere corn binder grease in there today ...I lost quite a bit of it because it was leaking around the fitting .....
__________________
Whether you think that you can,or that you can't,you are usually right....H.Ford |
07-30-2019, 03:06 AM | #2 |
Senior Member
Join Date: Apr 2015
Location: Sweden
Posts: 3,045
|
Re: Grease Fitting thread size....
Std 1/8 NPTF i would think....shouldn´t be anything odd there..
|
Sponsored Links (Register now to hide all advertisements) |
|
07-30-2019, 03:43 PM | #3 |
Senior Member
Join Date: Nov 2012
Location: Montrose,CO
Posts: 226
|
Re: Grease Fitting thread size....
Sponsored Links (Register now to hide all advertisements)
That’s what I was thinking too.... I over-think things sometime ..... Hardware store had everything I needed ........!! Works good....
__________________
Whether you think that you can,or that you can't,you are usually right....H.Ford |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|