|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-25-2019, 11:42 AM | #1 |
Senior Member
Join Date: May 2010
Location: Levelland, Tx
Posts: 418
|
installing pickup windows 41 ford pickup
doors spiffy clean and installed new window glass retainers also the two elevators to raise and lower........QUESTION: How do I connect the elevators to the retainer/window-glass ?
I have done it, almost. suggest fordman |
07-25-2019, 11:20 PM | #2 |
Senior Member
Join Date: May 2010
Location: MN
Posts: 7,057
|
Re: installing pickup windows 41 ford pickup
Sponsored Links (Register now to hide all advertisements)
The track is connected with spring loaded pieces to the window arms. Check drake, mac, carpenter, ebay, autozone, etc ***I should add. when installing the gummy "tape" adhesive to the track and window make sure the window is all the way up tight in place. (by hand) then connect the two. Otherwise it might not index right to the channel/glass. *** saw another thread that reminded me also. Tape thickness is also important. If this is what you are asking??? Hope this helps? guess I'm bored. Did a search for you https://www.fordbarn.com/forum/showt...ide+glass+1940 Purchased all my felt and channel stuff from drake. It was spot on but like most aftermarket needed some tlc. 3yrs later I'm happy. 38 truck. Same as a 41. . Last edited by Tinker; 07-26-2019 at 02:25 AM. |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|