Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 10-23-2020, 05:12 PM   #1
kimlinh
Member
 
Join Date: Nov 2014
Location: Middlebury,Connecticut
Posts: 90
Default Condenser check

Last time out in my A the car started running a little rough on the way home. I couldn't find anything wrong. I suspect something electrical. How can I check the condenser to see if it is starting to fail. Can I use my VOM to check its condition? ( I know, use a new one). Is anyone using a remote mounted condenser? How well does it work?

Thank you for your responses
kimlinh is offline   Reply With Quote
Old 10-23-2020, 08:11 PM   #2
Anteek29
Senior Member
 
Anteek29's Avatar
 
Join Date: Dec 2014
Location: Santa Maria, CA
Posts: 643
Default Re: Condenser check

Most fail during hot running condition...not measurable when cold.
__________________
Alan
1929 Special Coupe
1941 Pick-Up
1955 Victoria
Anteek29 is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 10-23-2020, 09:21 PM   #3
eagle
Senior Member
 
eagle's Avatar
 
Join Date: Aug 2011
Location: Eagle Bend, MN
Posts: 1,641
Default Re: Condenser check

Make sure your point gap hasn't closed up. Pull a spark plug strap off of a plug about a 1/4 inch and see if you have a nice hot steady spark. If its weak and or sporadic you may want to try a new condenser. You can test it with any DVOM that has a capacitance tester or else use an OHM meter, but it will likely test fine as you will be testing it cold. Otherwise get a can of Canned Air duster, hold it upside down and spray it on the condenser. That will cool it down. If the idle smooths out, replace the condenser. On the second question, yes you can install the condenser up on the firewall by the coil.
__________________
"There are some that can destroy an anvil with a teaspoon and shouldn't be allowed to touch anything resembling a tool."
eagle is offline   Reply With Quote
Old 10-24-2020, 06:01 AM   #4
Jacksonlll
Senior Member
 
Jacksonlll's Avatar
 
Join Date: Jul 2012
Location: Michigan-- Member of Oakleaf of MARC
Posts: 1,499
Send a message via ICQ to Jacksonlll
Default Re: Condenser check

Just turn the key on and open and close your points with your finger or a stick. The spark when you open the point should be a clean spark, not a big messy one. YOur condenser is probably just fine. Clean the plugs and check that point gap.
Jacksonlll is offline   Reply With Quote
Old 10-24-2020, 10:22 AM   #5
Will N
Senior Member
 
Will N's Avatar
 
Join Date: Jul 2010
Location: Pennsylvania
Posts: 806
Default Re: Condenser check

In my experience, when a condenser is going, it's a lack of power, not rough running, that is a symptom. Was it hot out the last time you took her out when it ran rough? It could have been the gas boiling in the carb bowl, causing alternating too rich/too lean conditions.
Will N is offline   Reply With Quote
Old 10-24-2020, 10:30 AM   #6
Purdy Swoft
Senior Member
 
Purdy Swoft's Avatar
 
Join Date: May 2010
Location: Alabama
Posts: 8,075
Default Re: Condenser check

Sponsored Links (Register now to hide all advertisements)
Many times when the condenser fails , after cooling it will restart and run for a short time .






.
Purdy Swoft is offline   Reply With Quote
Old 10-24-2020, 11:30 AM   #7
Kurt in NJ
Senior Member
 
Kurt in NJ's Avatar
 
Join Date: May 2010
Location: on the Littlefield
Posts: 5,282
Default Re: Condenser check

I used to collect condensers and test them, got good at changing them,had a lot of short term failures. Then I got the A&L burnout proof one, been 30 years, still good, have replaced the spare one several time replacing other peoples condensers though

I used the condenser checker on a dist machine, the failed ones many times worked again cold and would pass the test--till cooked in oven to 200 degrees
Kurt in NJ is offline   Reply With Quote
Old 10-24-2020, 01:13 PM   #8
duke36
Senior Member
 
Join Date: Jun 2015
Posts: 1,227
Default Re: Condenser check

If you belong to the MAFCA nat'l club, there is a new article about condensers.
duke36 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:33 AM.