Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 09-29-2020, 04:55 PM   #1
STAN WHITE
Senior Member
 
Join Date: Dec 2019
Location: Gardnerville, Nevada
Posts: 105
Default 33 Dash Gage Panel

I have a 33 Dash and I have the Bezel. I am going to use Stewart Warner Winged Gages. I will Engine Turn my own Panel. My question is how does it attach, There is the four tabs for the Bezel two on top and two on the bottom of the dash panel opening. There is also two tabs on the left and right side of the opening. Are these to attach the gage panel?. Does anyone know the thickness that the gage panel should be, Thanks for any help. Stan
STAN WHITE is offline   Reply With Quote
Old 09-29-2020, 08:38 PM   #2
Newc
Senior Member
 
Newc's Avatar
 
Join Date: May 2010
Posts: 1,360
Default Re: 33 Dash Gage Panel

Hi; The gauge panel fits inside the thin chrome bezel, and uses the same 4 mounting holes, so any thickness can fit inside the bezel, as long as the mount holes are usable. Even the thick aluminum ones fit inside the thin bezel. Newc
Newc is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 09-29-2020, 10:13 PM   #3
STAN WHITE
Senior Member
 
Join Date: Dec 2019
Location: Gardnerville, Nevada
Posts: 105
Default Re: 33 Dash Gage Panel

Sponsored Links (Register now to hide all advertisements)
Thanks Newc I appreciate your response. Thanks again! Stan
STAN WHITE is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:53 AM.