|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-07-2018, 11:26 PM | #1 |
Member
Join Date: Oct 2010
Location: auckland;new zealand
Posts: 53
|
FAM rubber replacements
I'm replacing the rear rubber mounts on my FAM mounts and need to raise the rear of the engine a couple of inches, where would be the place to place the jack ? have put it under the nut in front of the bell housing in the past but fear this is putting great stress on the drive gear.Any suggestions are welcome...thank you for your help in the past.
Vic |
05-08-2018, 05:11 AM | #2 |
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,834
|
Re: FAM rubber replacements
Use an old phone book between the sump and trolley jack pad.
__________________
Unfortunately, two half wits don't make a whole wit! |
Sponsored Links (Register now to hide all advertisements) |
|
05-08-2018, 05:41 AM | #3 |
Senior Member
Join Date: May 2010
Location: Auburn, MA
Posts: 2,106
|
Re: FAM rubber replacements
Sponsored Links (Register now to hide all advertisements)
__________________
“The technique of infamy is to start two lies at once and get people arguing heatedly over which is true.” ~ Ezra Pound |
|
|
Sponsored Links (Register now to hide all advertisements) |
|