|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-10-2014, 08:53 PM | #1 |
Member
Join Date: Oct 2010
Location: Red Beach New Zealand
Posts: 31
|
Drive shaft roller bearing shaft OD
I need to have my drive shaft bearing surface metal sprayed and turned down but am not sure of what size this should be. I understand the worn limit is 1.085". We have one shaft measuring 1.096" - is this the nominal size?
Cheers, Gavin |
01-11-2014, 12:09 PM | #2 |
Senior Member
Join Date: May 2010
Location: Rhode Island
Posts: 1,868
|
Re: Drive shaft roller bearing shaft OD
Would it be better to just swap it out with another one? Also I would think the original surface would be harden the same as the spindle bearing surface. Will you be able to duplicate that?
|
Sponsored Links (Register now to hide all advertisements) |
|
01-11-2014, 12:22 PM | #3 |
Senior Member
Join Date: Jun 2010
Location: Perry OH
Posts: 1,330
|
Re: Drive shaft roller bearing shaft OD
RonC there is a metal spray on process that can be applied that is hard. I used it 40 years ago.
it was sold by EutecticCastoline. I think that was the name of the Co. Not an easy prosess. JMHO |
01-11-2014, 12:28 PM | #4 |
Senior Member
Join Date: May 2010
Location: Rhode Island
Posts: 1,868
|
Re: Drive shaft roller bearing shaft OD
Jim, That's good to know. Any idea of cost ?
|
01-11-2014, 03:03 PM | #5 |
Member
Join Date: Oct 2010
Location: Red Beach New Zealand
Posts: 31
|
Re: Drive shaft roller bearing shaft OD
I have found the bearing surface pitted and unsuitable for the bearing to run on after the driveshaft has been modified to fit a Leycock overdrive. A pity I did not find this earlier. I can always use 1.096" but would prefer to have the original size confimed. Cheers,
Gavin |
01-11-2014, 03:27 PM | #6 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,750
|
Re: Drive shaft roller bearing shaft OD
Sponsored Links (Register now to hide all advertisements)
repairing this area. Bob |
01-15-2014, 01:07 PM | #7 |
Member
Join Date: Oct 2010
Location: Red Beach New Zealand
Posts: 31
|
Re: Drive shaft roller bearing shaft OD
Bob C,
Thanks for your suggestion but Tom Endy was unable to help. However, Tom Jordan of Snyders confirmed the 1.096" dimension which is much appreciated. Cheers, Gavin |
01-15-2014, 08:33 PM | #8 |
Senior Member
Join Date: Aug 2010
Location: Geelong Australia
Posts: 119
|
Re: Drive shaft roller bearing shaft OD
Just a side question regarding this bearing ,,has anyone replaced this bearing with a series of say 3 ball type sealed bearings to replicate the same dimension of the original ,,i presume machining of the shaft and T,tube to accomadate the bearing would be difficult ,,
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|