|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-15-2020, 05:12 PM | #1 |
Senior Member
Join Date: Apr 2019
Location: Mt. Pleasant, SC
Posts: 601
|
Polarizing a generator
I’ve read a lot of posts on this, but the procedure still isn’t completely clear to me.
I’ve just disassembled a generator to re-wrap the field coils with Scotch glass electrical tape, and then cleaned and re-assembled it. It will motor with my 6 volt 10 amp battery charger attached to it - negative to output post and positive to generator case. If I connect a multimeter to the unit while spinning it in normal rotation direction, Ican measure 70 mV on it - no cutout attached. Questions - is a battery charger enough to polarize the generator ? If the generator is working, should I see more than 70 mV at the output ? Thanks - Jim |
12-15-2020, 05:44 PM | #2 |
Senior Member
Join Date: May 2010
Location: Pine, AZ
Posts: 794
|
Re: Polarizing a generator
When you motored the generator, it should have been enough to get the armature magnetized, probably not as much as shorting across the cutout with piece of wire for a very short time when attached to the battery in the vehicle . How fast did you spin the generator to do your voltage measurement? Did you measure the voltage on the output of the generator instead of the cutout? Have you checked the 3rd brush connection? How clean is the commutator( the copper segments the brushes rub on). The commutator can be polished up with very fine sandpaper or crocus cloth.
|
Sponsored Links (Register now to hide all advertisements) |
|
12-15-2020, 06:04 PM | #3 |
Senior Member
Join Date: Apr 2019
Location: Mt. Pleasant, SC
Posts: 601
|
Re: Polarizing a generator
I polished the commutator, so it looks quite good, and all brush connections are clean. I used a cordless electric drill to spin the armature, so probably not much faster than 100-150 rpm. That may be the reason for the low voltage measurement.
|
12-15-2020, 08:46 PM | #4 |
Senior Member
Join Date: May 2010
Location: Largo Florida
Posts: 7,225
|
Re: Polarizing a generator
As said, adding power to motor the generator should polarize it.
But, to polarize it just jump across the cutout terminals for a nano-second. [ original type cut-out] Once installed if the generator has low or no output trying adjusting the third brush. |
12-16-2020, 03:01 PM | #5 |
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,436
|
Re: Polarizing a generator
Sponsored Links (Register now to hide all advertisements)
Motoring by itself is not always a good indication that the components are all good to go. Polarizing or flashing the field with a DC current should give the pole shoes a good magnetic gauss. If there is no residual magnetism then the generator won't put out enough current to close the cut out switch. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|