|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
02-17-2013, 12:02 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Ottawa, Illinois
Posts: 401
|
Distributor bolt
How tight does one tighten the distributor bolt on the side of the block?
|
|
|
|
02-17-2013, 12:43 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Portland OR
Posts: 6,340
|
Re: Distributor bolt
Just tight enough to hold it in place. The pin should keep it from turning. Make sure the distributor is fully seated in the block. The screw fits in the groove in the distributor keeping it from moving up and down.
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
02-17-2013, 01:29 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Posts: 332
|
Re: Distributor bolt
Don't forget the lock nut
|
|
|
|
|
02-17-2013, 01:40 PM
|
#4 |
|
Senior Member
Join Date: May 2010
Location: NC
Posts: 2,975
|
Re: Distributor bolt
There is no bolt on the side of the block. Are you talking about the one on the head. Is so just snug not real tight. To tight will bind the distributor shaft.
|
|
|
|
|
02-17-2013, 09:36 PM
|
#5 |
|
Senior Member
Join Date: May 2010
Location: Ottawa, Illinois
Posts: 401
|
Re: Distributor bolt
Sponsored Links (Register now to hide all advertisements)
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:07 AM.