|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-12-2023, 09:19 AM | #21 |
Senior Member
Join Date: Aug 2021
Location: Germany: Cologne and Witten
Posts: 305
|
Re: ...what is wrong with my sockets?
|
10-25-2023, 05:47 PM | #22 |
Member
Join Date: Feb 2012
Location: Gulf Shores, AL
Posts: 78
|
Re: ...what is wrong with my sockets?
I have the same LED's and the same problem. They were great when I first installed them, but they started flickering on the low beams. When I removed them I noticed that the solder bumps; where they touch the socket contact points, were quite worn. I added solder to the bulb contacts and squeezed the socket with a pair of channel locks to tighten everything. The bulbs are heavier than the original incandescent bulbs and tend to vibrate and bounce more. I tried tightening the focus screw on the headlight bucket, but I just got to the point of shorting out the bulb. I like CT's process because with the original design, the bulbs would need replaced before the solder contacts would wear out. I believe that Logo Lites could sell improved sockets along with their light bulbs.
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|