|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-22-2016, 07:20 AM | #1 |
Senior Member
Join Date: Apr 2016
Location: Brookshire & Cat Spring,Texas
Posts: 222
|
Need Confirmation On Head Gasket Placement...
Copper type head gasket. Does the raised crimped edge side go towards the block and flat side go towards the head? thanks...
|
05-22-2016, 07:33 AM | #2 |
Senior Member
Join Date: May 2010
Location: Tulsa OK
Posts: 476
|
Re: Need Confirmation On Head Gasket Placement...
The larger water hole goes to the rear. The smaller water hole goes at the front. The crimp location is not important.
__________________
1910 Touring 1914 Touring 1915 Touring 1917 Torpedo Runabout |
Sponsored Links (Register now to hide all advertisements) |
|
05-22-2016, 07:44 AM | #3 |
Senior Member
Join Date: May 2010
Location: Asheville,NC
Posts: 3,104
|
Re: Need Confirmation On Head Gasket Placement...
The crimp goes to the head. There is always a slight amount of movement between the head and block which will etch the gasket into the cast. It is easier to re-surface the head than the block to get rid of this.
__________________
http://www.model-a-ford-4bangers.com/ |
05-22-2016, 09:20 AM | #4 |
Senior Member
Join Date: May 2010
Location: Portland OR
Posts: 6,342
|
Re: Need Confirmation On Head Gasket Placement...
Crimp side up. As James said above.
|
05-22-2016, 09:47 AM | #5 |
BANNED
Join Date: May 2010
Location: Bucks County, PA
Posts: 11,454
|
Re: Need Confirmation On Head Gasket Placement...
Go with posts 3 & 4....
|
05-22-2016, 11:59 AM | #6 |
Senior Member
Join Date: Sep 2014
Location: oroville calif
Posts: 893
|
Re: Need Confirmation On Head Gasket Placement...
Sponsored Links (Register now to hide all advertisements)
|
05-22-2016, 04:55 PM | #7 |
BANNED
Join Date: May 2010
Location: Michigan / Ontario border, Sarnia, Ontario. 50 miles from Detroit and 150 from Toronto.
Posts: 5,800
|
Re: Need Confirmation On Head Gasket Placement...
Mr. Rogers is an expert, follow his advice and you can never go wrong! Wayne
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|