|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-06-2016, 08:23 PM | #1 |
Senior Member
Join Date: May 2010
Location: Virginia
Posts: 210
|
40/41 Pickup-Heater Ducts/Vents
Did Ford equip 40/41 Pickups with heater/defrost ducts in the dash or were they part of heater kits installed by the dealership or others? Thanks
|
01-06-2016, 08:36 PM | #2 |
Senior Member
Join Date: May 2010
Location: Northridge, CA
Posts: 236
|
Re: 40/41 Pickup-Heater Ducts/Vents
Yes, there are cutouts directly below the windshield garnish molding louvers to admit the warm air for defrosting. The defrost nozzles connect to those cutouts. The 1940 truck cabs have a smaller cutout than the 1941 cab. Correct defroster nozzles for these trucks are different from those used on the passenger cars. The truck nozzles are curved and difficult to find. Good luck.............40larry
|
Sponsored Links (Register now to hide all advertisements) |
|
01-07-2016, 09:38 AM | #3 |
BANNED
Join Date: May 2011
Posts: 409
|
Re: 40/41 Pickup-Heater Ducts/Vents
Oval slots above instrument and glove box hole are where nozzles install. This is a NOS cowl for 1942-1947, 1941 is the same.
|
01-07-2016, 10:54 AM | #4 |
Senior Member
Join Date: Sep 2011
Location: Black Hills, SD
Posts: 577
|
Re: 40/41 Pickup-Heater Ducts/Vents
I noticed my 40 tonner panel has tiny little slots, not even 2 fingers wide and the 47 parts truck has much larger ones. When I have the windshield out I am going to enlarge them to the larger size. Good defrosters are pretty important where I live.
|
01-07-2016, 04:52 PM | #5 |
BANNED
Join Date: May 2011
Posts: 409
|
Re: 40/41 Pickup-Heater Ducts/Vents
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|