|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-19-2017, 08:22 AM | #1 |
Senior Member
Join Date: Oct 2015
Posts: 140
|
160B header gap?
Replacing the header on my 160B. I hope. in both corners the gaps seem large, it looks like an original header with some water damage. the top was replaced a while back by PO. Did Henry do it this way? the entire seam was covered by hidem. thanks,
the gap is 5/16 to 3/8 inch, and for all the Kiwi's and Brits 13mm.
__________________
Richard in New Bern. When everything seems to be going against you, remember that the airplane takes off against the wind, not with it” - Henry Ford Last edited by richsfords; 03-19-2017 at 09:10 AM. Reason: add measurment |
03-19-2017, 06:22 PM | #2 |
Senior Member
Join Date: Jun 2015
Posts: 1,414
|
Re: 160B header gap?
the gap appears about right and gets covered by orig. metal or aluminum (replacement) moulding available from the vendors, not hidem welt.
|
Sponsored Links (Register now to hide all advertisements) |
|
03-19-2017, 09:58 PM | #3 |
Senior Member
Join Date: May 2010
Location: Auburn Washington
Posts: 2,552
|
Re: 160B header gap?
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|