11-04-2012, 09:18 PM | #1 |
Senior Member
Join Date: May 2010
Location: Dallas
Posts: 1,053
|
carb linkage
Im using the stock long carb linkage, where the ends pull out to slip the ball in.
when I put the stock double return carb springs on, it was way hard, and pulled hard at the long linkage ends, so I put just one spring on it, the carbs snap back ok, but it still pulls at both the linkage ends when pushing the gas peddle, not to bad, but still does. so my question is, when you mash the gas peddle, is it suppose to pull at the long linkage ends ? Is there a chance it will pull it apart ? thanks.. Last edited by elwood; 11-04-2012 at 09:26 PM. |
11-04-2012, 09:25 PM | #2 |
Senior Member
Join Date: Jul 2011
Location: SF Bay Area
Posts: 6,641
|
Re: carb linkage
Sponsored Links (Register now to hide all advertisements)
__________________
Alan |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|