|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-22-2016, 04:40 PM | #1 |
Junior Member
Join Date: Jun 2014
Posts: 12
|
Need help in Central Ohio
Hello:
I am trying to finish the restoration on my father's 28 Tudor, I normally do 60's era GM Muscle Cars, to say I am out of my element is an understatement. I am trying to install the trans/bellhousing unit to the rebuilt engine in the car. I am having trouble getting the gears inside the trans to slide or get adjustment in the throwout brg assm. Any help would be great. Thanks, Ron 614 309 1513 |
10-22-2016, 05:01 PM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,755
|
Re: Need help in Central Ohio
I'm a little confused. In the first sentence you say you are trying to install the trans
to the engine and in the next sentence you say you are having trouble adjusting the throw out bearing which would mean the trans is bolted to the engine. Is the rear end hooked to the trans yet? Is the clutch a single plate or multi plate? Bob |
Sponsored Links (Register now to hide all advertisements) |
|
10-22-2016, 05:13 PM | #3 |
Senior Member
Join Date: Jul 2014
Location: Dublin, OH & Clyde, NC
Posts: 494
|
Re: Need help in Central Ohio
We have a great club in central Ohio, if you reach out I'm sure someone will help.
http://themodelaclub.org
__________________
1930 Deluxe Coupe "Sister" |
10-23-2016, 08:33 AM | #4 |
Senior Member
|
Re: Need help in Central Ohio
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|