|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-24-2018, 07:00 PM | #1 |
Member
Join Date: Oct 2010
Location: auckland;new zealand
Posts: 53
|
Starter motor overhaul
The copper button on my starter motor is quite pitted so I intend to replace it....any advice on how to go about this would be appreciated...many thanks Vic
|
09-24-2018, 08:07 PM | #2 |
Senior Member
Join Date: May 2010
Location: on the Littlefield
Posts: 6,156
|
Re: Starter motor overhaul
file it down some you need a high wattage soldering iron, I use a 600 watt one, a torch will burn the insulators, a low wattage iron will not get the heat high fast enough, insulation will smoke some ---even char
In my specs I have ---11/32 -- to 3/8 high, if it cleans up in that range don't worry ---you don't need to eliminate all the pits |
Sponsored Links (Register now to hide all advertisements) |
|
09-24-2018, 10:00 PM | #3 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 8,099
|
Re: Starter motor overhaul
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|