Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 04-23-2020, 09:55 AM   #1
rer_239
Senior Member
 
rer_239's Avatar
 
Join Date: May 2010
Location: muskegon, mi
Posts: 199
Default Generator (inside) wiring

1 short wire from inside of case to ?
2 red wire from field coil to?
3 yellow wire from field coil to?

Thanks
Dick
rer_239 is offline   Reply With Quote
Old 04-23-2020, 12:04 PM   #2
Kurt in NJ
Senior Member
 
Kurt in NJ's Avatar
 
Join Date: May 2010
Location: on the Littlefield
Posts: 5,445
Default Re: Generator (inside) wiring

Sponsored Links (Register now to hide all advertisements)
The original generators had the field ground attached to the housing, other wire to 3rd brush, one brush has short ground wire to end plate, other brush to terminal post

later generator has one field wire connected to 3rd brush, other wire comes out rubber bushing to be used with oval cutout that has voltage regulator, if no regulator it gets attached to ground at cutout screw, other wire coming out rubber bushing goes to brush opposit grounded brush---other end attaches to cutout(power wire)----
Kurt in NJ is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 09:21 PM.