|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-11-2020, 06:36 PM | #1 |
Senior Member
Join Date: Sep 2010
Posts: 153
|
Spartan Ahooga horn question
To connect it wire goes to center terminal between the 2 posts I would assume. Is the other screw that is exposed outside the cover for sound adjustment?
Looked on line couldn't find anything |
09-11-2020, 07:01 PM | #2 |
Senior Member
Join Date: May 2010
Location: Spruce Pine, NC
Posts: 1,458
|
Re: Spartan Ahooga horn question
Two wires go into the horn, they plug into separate terminals.
the screw you reference is for the adjustment of diaphragm tension.
__________________
our next Model A is out there in the unknown...... |
Sponsored Links (Register now to hide all advertisements) |
|
09-11-2020, 07:14 PM | #3 |
Senior Member
Join Date: Aug 2012
Location: South East Wisconsin
Posts: 1,279
|
Re: Spartan Ahooga horn question
Yes, and the two wires plug in 180 degrees apart facing each other.
|
09-11-2020, 07:15 PM | #4 |
Senior Member
Join Date: Apr 2015
Location: Boise, Idaho
Posts: 1,578
|
Re: Spartan Ahooga horn question
The bullets on the wires slip into the clips in direction shown by the arrows.
__________________
Early '29 CCPU that had a 4-speed, but not any more.......in the family since '62 |
09-11-2020, 07:44 PM | #5 |
Senior Member
Join Date: Sep 2010
Posts: 153
|
Re: Spartan Ahooga horn question
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|