|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-04-2017, 09:09 PM | #1 |
Senior Member
Join Date: Dec 2015
Posts: 547
|
8ba flathead pilot and generator bearings
On an 8ba, are the sealed pilot bearings the same as the generator bearing? I heard that somewhere and wanted to check
JB |
09-04-2017, 09:26 PM | #2 |
Senior Member
Join Date: Nov 2010
Location: NM
Posts: 2,438
|
Re: 8ba flathead pilot and generator bearings
Ball bearing pilot: NATIONAL Part # 203S Bore=0.6693", Outer Diameter=1.5748", Width=0.4724"
__________________
'52 F-1, EAB flathead |
Sponsored Links (Register now to hide all advertisements) |
|
09-07-2017, 10:40 AM | #3 |
Senior Member
Join Date: Oct 2015
Location: Socal
Posts: 795
|
Re: 8ba flathead pilot and generator bearings
I'd be interested in knowing the generator size or part #.
Just went through the Delco alternator on my flathead and even with the internet assist that was a huge exercise in "I got a secret." I actually had to get them both out of the thing and measure them. |
09-07-2017, 11:36 AM | #4 |
Senior Member
Join Date: Nov 2010
Location: NM
Posts: 2,438
|
Re: 8ba flathead pilot and generator bearings
Appears to be a slight difference in width, otherwise the same.
__________________
'52 F-1, EAB flathead |
09-07-2017, 01:07 PM | #5 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,755
|
Re: 8ba flathead pilot and generator bearings
I looked in my bearing interchange and came up with this.
Pilot B-7600 ID .6693, OD 1.5748, W .4724 Single shield Generator 7RA-10094 ID .6693, OD 1.5748, W .4724 2 seals |
09-07-2017, 02:19 PM | #6 |
Senior Member
Join Date: Dec 2015
Posts: 547
|
Re: 8ba flathead pilot and generator bearings
Sponsored Links (Register now to hide all advertisements)
JB |
|
|
Sponsored Links (Register now to hide all advertisements) |
|