01-06-2018, 04:56 PM | #1 |
Senior Member
Join Date: May 2010
Location: Upland Ca
Posts: 274
|
Frame welting
Getting ready to put the welting on my 29 Business Coupe, can someone tell me where it starts and ends on the frame?
|
01-06-2018, 05:02 PM | #2 | |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Re: Frame welting
Quote:
http://www.plucks329s.org/pdf/studie...EAKARTICLE.pdf Pluck |
|
Sponsored Links (Register now to hide all advertisements) |
|
01-06-2018, 08:54 PM | #3 |
Senior Member
Join Date: May 2010
Location: Upland Ca
Posts: 274
|
Re: Frame welting
Still not clear, on a 29 Coupe, where on the frame does it start and where on the frame does it stop?
|
01-06-2018, 09:39 PM | #4 | |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Re: Frame welting
Quote:
Pluck Last edited by Steve Plucker; 01-07-2018 at 01:24 AM. |
|
01-06-2018, 10:25 PM | #5 |
Senior Member
Join Date: May 2010
Location: Upland Ca
Posts: 274
|
Re: Frame welting
Forget it! I’m so tired of not being able to get a simple answer here!
|
01-06-2018, 10:48 PM | #6 |
Senior Member
Join Date: May 2010
Location: Santee, California
Posts: 3,505
|
Re: Frame welting
Sponsored Links (Register now to hide all advertisements)
|
01-06-2018, 11:23 PM | #7 |
Senior Member
Join Date: May 2010
Location: Upland Ca
Posts: 274
|
Re: Frame welting
Thanks
|
01-08-2018, 12:31 AM | #8 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Frame welting
Tape the ends and let it set for a day before punching the holes. I found it tends to shrink a little after it's unrolled.
|
01-08-2018, 12:48 PM | #9 |
Senior Member
Join Date: Aug 2017
Location: SoCal Desert
Posts: 826
|
Re: Frame welting
While mine is not a coupe, my 31 Tudor's welting runs from the front to rear, ... Full length of the frame. I'm going to be adding mine soon as well as I just finished making her a rolling chassis again.
I have the self adhesive backed version. That's what's on there now and from what I have read, ... it makes the job 10x easier. Regards Bill Last edited by BillCNC; 01-08-2018 at 01:31 PM. |
01-08-2018, 01:25 PM | #10 | |
Senior Member
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,508
|
Re: Frame welting
Quote:
|
|
01-08-2018, 01:35 PM | #11 |
Senior Member
Join Date: Aug 2017
Location: SoCal Desert
Posts: 826
|
Re: Frame welting
Brent,
I understand that. I figured since they give you 20", ... enough for both frame rails to be covered their entire length, why not. Regards Bill |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|