|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-01-2016, 05:42 PM | #1 |
Senior Member
Join Date: May 2010
Posts: 295
|
Timing Gear Aligning Mark
I have a knock in my Speedster engine that I can't locate or diagnose. The bronze timing gear I purchased and installed had a very shallow aligning mark so I enlarged it quite a bit to feel the timing mark easily.
Does the thrust spring mechanism ride on the timing gear circle where the aligning mark is located? Did I ruin the bronze gear by drilling the hole deeper? Is it immaterial how deep I drilled the hole in the bronze timing gear? Bill Lee/Virginia Peninsula |
11-01-2016, 05:59 PM | #2 |
BANNED
Join Date: May 2010
Location: Bucks County, PA
Posts: 11,454
|
Re: Timing Gear Aligning Mark
The spring and button presses on the center of the camshaft to hold it from floating..
I doubt u caused any issue by making the timing pin hole more pronounced |
Sponsored Links (Register now to hide all advertisements) |
|
11-02-2016, 07:01 PM | #3 |
Senior Member
Join Date: May 2010
Posts: 295
|
Re: Timing Gear Aligning Mark
Sponsored Links (Register now to hide all advertisements)
Bill Lee/Virginia Peninsula |
|
|
Sponsored Links (Register now to hide all advertisements) |
|