|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-27-2018, 07:00 PM | #1 |
Member
Join Date: Jan 2018
Posts: 54
|
Hole Size & Location on 1931 Running Board Shield for a Well Fender
Is there a template or information regarding the Hole Size & Location on a 1931 Running Board Shield for the Well Fender Arm to fit through?
Also, do you have any suggestions/advice from prior experience? The prior owner has had a well installed in the front fender, but the running board shield does not have a hole for the arm. Thank you. |
05-27-2018, 08:40 PM | #2 |
Senior Member
Join Date: May 2010
Location: GA 30809
Posts: 629
|
Re: Hole Size & Location on 1931 Running Board Shield for a Well Fender
I have the instructions for making and using a locating tool for side mount holes in an album on my FordBarn page. Here is the link.
https://www.fordbarn.com/forum/album...ictureid=20356 |
Sponsored Links (Register now to hide all advertisements) |
|
05-27-2018, 11:05 PM | #3 |
Senior Member
Join Date: May 2010
Location: brentwood, ca
Posts: 4,233
|
Re: Hole Size & Location on 1931 Running Board Shield for a Well Fender
I remember reading that the hole locations for riveting the spare tire bracket on the frame are stamped on the frame. Take a close look. I may be more right than wrong
|
05-28-2018, 04:40 AM | #4 | |
Senior Member
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
|
Re: Hole Size & Location on 1931 Running Board Shield for a Well Fender
Quote:
Minerva had NO side mounts, but a hole in the forward part of the running board shield had been welded SHUT! She was an Early '30 Std. Coupe. Bill Williamson
__________________
"THE ASSISTANT GURU OF STUFF" |
|
05-28-2018, 11:26 AM | #5 |
Senior Member
Join Date: May 2010
Location: brentwood, ca
Posts: 4,233
|
Re: Hole Size & Location on 1931 Running Board Shield for a Well Fender
Bill, key word is early 30 car. Keep the line moving.
I thought I saw a picture of the indents for locating the bracket on the frame. |
05-28-2018, 12:27 PM | #6 |
Senior Member
Join Date: May 2010
Location: Southern Maine
Posts: 1,497
|
Re: Hole Size & Location on 1931 Running Board Shield for a Well Fender
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|