Torque Tube Drive Shaft Kits

[HIGHTOWER611]

Now available is the remaining stock of Dick Spadaros' Torque Tube Drive Shaft Kits.

**A cut to length drive shaft for your cut-down torque tube banjo rear or your torque tube Quickchange. A qualified welder should do the welding in a fixture to control runout. I just use a driveshaft shop. I accept no responsibility as I am only moving the remaining stock.

**Great for A-V8 conversions or altered wheel base cars.

**Fits Ford 6 spline pinion and 10 spline also available. Please specify.

**Fits Early Ford U-Joint

**Uses stock speedometer drive gear

**Supplied with 60" drive shaft tube that can be cut to your length. The shaft material is .060

There are several units here in Canada and more in the US. The initial stock is machined to fit the .060 shaft and later stock may have to be final machined where the tube slides over. When they are gone, they are gone. They can be shipped from the US when there is sufficient orders as I am not close to the border.
The cost is the same as he was selling in his old price list. When Speedway sold their version (Chinese?) they were $330. They have no more stock.

3 Pieces per unit as shown in the pictures. USA made. $299. USD plus shipping.

I will respond as quickly as possible to questions but work many hours.

[HIGHTOWER611]

bump

[HIGHTOWER611]

Sponsored Links (Register now to hide all advertisements)

I will be in Hershey with a couple of these kits Tuesday and Wednesday. Please contact me here by Sunday to arrange to meet up at the show. The number of remaining kits is limited.