|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
09-20-2012, 06:30 PM
|
#1 |
|
Member
Join Date: Sep 2011
Location: Lebanon Mo
Posts: 36
|
Getting Cam off Distributor ?
I'm having a problem getting the points cam off the distributor shaft. The hold-down screw was extremely tight and now that I have it off the cam it will not slide off the shaft. I'm putting new points in and want to reset the timing and remove the top plate. Any Suggestion???
Jim |
|
|
|
09-20-2012, 06:47 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Clinton,WA/Whidbey Island
Posts: 4,102
|
Re: Getting Cam off Distributor ?
lubricating oil and maybe some easy prying! Should slide up with ease!! Good Luck.
__________________
www.whidbeymodelaclub.com |
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
09-20-2012, 07:02 PM
|
#3 |
|
Member
Join Date: Sep 2011
Location: Lebanon Mo
Posts: 36
|
Re: Getting Cam off Distributor ?
Got It !!
Put some PB-Blaster on it. Waited 15 minutes the preyed with screw drive while tapping cam with small hammer. Thanks Jim |
|
|
|
|
09-21-2012, 10:52 AM
|
#4 |
|
Senior Member
Join Date: May 2010
Location: new britain,ct 06052
Posts: 9,390
|
Re: Getting Cam off Distributor ?
Sponsored Links (Register now to hide all advertisements)
Paul in CT |
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 10:24 PM.