|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-20-2015, 12:14 PM | #1 |
Senior Member
Join Date: Jun 2012
Location: Eagan mn
Posts: 132
|
adjusting valves
starting to reassemble my 59ab with 8ba crank. so should I install the valves and set them then the crank? or what is the most popular way in starting? all new parts.
thanks |
03-20-2015, 01:47 PM | #2 |
Senior Member
Join Date: May 2010
Location: Solihull, England.
Posts: 8,743
|
Re: adjusting valves
It's not a bad way to do it. I think I did my last one that way. Cam, valvegear, crank, rods and pistons in that order.
Mart. |
Sponsored Links (Register now to hide all advertisements) |
|
03-20-2015, 02:25 PM | #3 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 10,919
|
Re: adjusting valves
It would be easier to rotate the crank if the rods and pistons are not yet installed.
|
03-20-2015, 09:55 PM | #4 |
Senior Member
Join Date: Oct 2011
Location: Shelton, WA
Posts: 3,799
|
Re: adjusting valves
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|