|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-26-2021, 07:40 PM | #1 |
Member
Join Date: Aug 2011
Posts: 35
|
1940 deluxe fordor window regulator
I replaced window channels and felt on front doors. Window rolled up and down just fine until I installed door panel and garnish moulding. The glass now comes out of channel when I roll the window down about 3 or so inches. If I put pressure on the glass with my hand it will roll down as expected. Am I missing some sort of adjustment or something to keep it from popping out.
|
05-26-2021, 07:55 PM | #2 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 3,260
|
Re: 1940 deluxe fordor window regulator
I don’t understand how the glass can come out of the channel . Could it be the glass is too small ?? Maybe the door panel is too thick ?
|
Sponsored Links (Register now to hide all advertisements) |
|
05-26-2021, 09:23 PM | #3 |
Senior Member
Join Date: Jan 2019
Location: Chicago
Posts: 731
|
Re: 1940 deluxe fordor window regulator
Sponsored Links (Register now to hide all advertisements)
If that’s what is happening, may need to fine tune the lateral location of the whole window assembly by loosening the bolts (four I think) holding the regulator to door. Regulator is slotted to allow for fine adjustment there. 1/16” may do it. 1/8” may be too much and will fall out on the other side. Temporarily install garnish molding without the door panel while futzing with this. Can be aggravating. Last edited by JayChicago; 05-26-2021 at 09:46 PM. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|