|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-15-2013, 09:03 AM | #1 |
Senior Member
Join Date: May 2010
Location: Bucks Co, Pa
Posts: 3,740
|
Clutch indication
I checked the archives and couldn't find anything. So... I've got a good used clutch, but I'm concerned about the fingers. I just set a T.O. bearing on the fingers and it rocks about 1/8". By my calculations, it shouldn't rock at all. I've got to be right on this one. But How high should the fingers be. Is there a height for the fingers? Or just even, in the same plane? Thanks in advance
Terry |
08-15-2013, 09:46 AM | #2 |
Senior Member
Join Date: May 2010
Location: Epping N.H.
Posts: 2,990
|
Re: Clutch indication
Terry,you need to check the fingers with the pressure plate bolted to the flywheel with the disc you are going to use.They need to be even at that point.In theory the levers on a plate should all be even at rest without the springs compressed,but in real life it doesn't seem to work that way.
|
Sponsored Links (Register now to hide all advertisements) |
|
08-15-2013, 10:03 AM | #3 |
Senior Member
Join Date: May 2010
Location: Largo Florida
Posts: 7,225
|
Re: Clutch indication
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|