The Ford Barn

joe plumber · 05-25-2017, 06:36 PM

Anyone heard anything about the 94 Edelbrock carb,good ,bad or otherwise

baldmustang · 05-25-2017, 07:19 PM

I put one on my 51 F1 flathead. Started up easy, runs great. Very Happy. Did not have to adjust. I bought it from Midwest. It was expensive $324.00

Unfortunately, I don't get to drive it much. Probably ran two tanks of gas through it so far.

joe plumber · 05-25-2017, 07:39 PM

The cheapest I have found so far is a a little over$400

Ole Don · 05-26-2017, 08:35 AM

Anything Edelbrock will be good. The name is on the part. The four barrels come with a book on how to tune, read it.

TedEaton · 05-26-2017, 08:08 PM

Sponsored Links (Register now to hide all advertisements)

I put a trio of them on a warmed over 272 Y-Block. Due to camshaft being a bit on the wild side, the idle feed restrictions in each carb had to be reduced in size. Here's the link to the article that was published in Y-Block Magazine which goes into more detail on the modifications performed to the Edelbrock 94 carbs.
http://www.eatonbalancing.com/2015/0...ng-up-the-272/
Ted Eaton.

05-25-2017, 06:36 PM	#1
joe plumber Senior Member Join Date: May 2010 Posts: 820	New Edelbrock 94 Anyone heard anything about the 94 Edelbrock carb,good ,bad or otherwise

05-25-2017, 07:19 PM	#2
baldmustang Junior Member Join Date: Jul 2014 Location: Tracy CA Posts: 22	Re: New Edelbrock 94 I put one on my 51 F1 flathead. Started up easy, runs great. Very Happy. Did not have to adjust. I bought it from Midwest. It was expensive $324.00 Unfortunately, I don't get to drive it much. Probably ran two tanks of gas through it so far.

05-25-2017, 07:39 PM	#3
joe plumber Senior Member Join Date: May 2010 Posts: 820	Re: New Edelbrock 94 The cheapest I have found so far is a a little over$400

05-26-2017, 08:35 AM	#4
Ole Don Senior Member Join Date: May 2010 Location: St. Michael, Minnesota Posts: 1,713	Re: New Edelbrock 94 Anything Edelbrock will be good. The name is on the part. The four barrels come with a book on how to tune, read it.

05-26-2017, 08:08 PM	#5
TedEaton Senior Member Join Date: Nov 2012 Location: Central Texas Posts: 155	Re: New Edelbrock 94 Sponsored Links (Register now to hide all advertisements) I put a trio of them on a warmed over 272 Y-Block. Due to camshaft being a bit on the wild side, the idle feed restrictions in each carb had to be reduced in size. Here's the link to the article that was published in Y-Block Magazine which goes into more detail on the modifications performed to the Edelbrock 94 carbs. http://www.eatonbalancing.com/2015/0...ng-up-the-272/ Ted Eaton.