The Ford Barn

GaryU. · 05-04-2019, 05:06 PM

Bought a couple small boxes of Flathead parts at a swap meet last week and have been going through them to decide what to discard. There was a very gummed up rotor shaft and weights that I took part and cleaned yesterday that turned out to work very nicely. I was going to use this setup in a distributor that needed a rebuild when I figured out it wouldn't fit, too long. Compared to another and figured out it was for Lincoln not Ford. Went through more parts and a few more popped up including an old condenser marked Zephyr as well as two new ones. Not sure about vacuum lines especially the one on the left. Don't have a use for these parts and looking at boos-herril.com am unsure of value if I sell them. Any input is appreciated. And yes the rotors are not for Lincoln.

Ken/Alabama · 05-04-2019, 09:29 PM

Looks like Lincoln. Look on the tang end of the shaft and if it has an "H" stamped on it that would confirm Lincoln.

GaryU. · 05-05-2019, 05:32 AM

Has 46 H stamped on tang.

marko39 · 05-05-2019, 07:10 AM

the condensers are most liklely no good. test them to be sure.

Ken/Alabama · 05-05-2019, 01:54 PM

Sponsored Links (Register now to hide all advertisements)

Quote:

Originally Posted by GaryU.

Has 46 H stamped on tang.

Yep, That's Lincoln

05-04-2019, 09:29 PM	#2
Ken/Alabama Senior Member Join Date: May 2010 Location: Alabama Posts: 3,260	Re: Lincoln V-12 Distributor Parts Looks like Lincoln. Look on the tang end of the shaft and if it has an "H" stamped on it that would confirm Lincoln.

05-05-2019, 05:32 AM	#3
GaryU. Senior Member Join Date: May 2010 Location: Beaver Dam, Wisconsin Posts: 821	Re: Lincoln V-12 Distributor Parts Has 46 H stamped on tang.

05-05-2019, 07:10 AM	#4
marko39 Senior Member Join Date: Oct 2016 Location: harpursville ny Posts: 1,040	Re: Lincoln V-12 Distributor Parts the condensers are most liklely no good. test them to be sure.