Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 01-31-2014, 05:27 PM   #1
1930artdeco
Senior Member
 
1930artdeco's Avatar
 
Join Date: May 2010
Location: Oakland, CA
Posts: 2,622
Default steering ball replacement

I need to replace the steering spindles on my car. I purchased some that have a pressed on ball and then are tack welded and cleaned up. I am no expert but I was a little worried that the small weld would not hold up.

So I ordered some of the ball stud combos and am going to have the old balls cut off (please leave the comments at the door) and new ones welded on.

Can anyone tell me the benefits of either strategy on these? Which one is better?

Mike
__________________
1930 TownSedan (Briggs)
Still learning after all these years....
1930artdeco is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 08:47 PM.