|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-02-2010, 07:50 AM | #1 |
Member
Join Date: May 2010
Location: Preston,ct
Posts: 76
|
60hp head gasket
I'm looking for recommendations for head gaskets for my 60hp. Copper, steel, composite? MAC's looks good, any suggestions? Thanks, Marv Stuart, MGTD-V860.
|
09-02-2010, 08:06 PM | #2 |
Senior Member
Join Date: May 2010
Location: Windham, CT
Posts: 702
|
Re: 60hp head gasket
Are your heads Aluminum? Most feel it/s best not to use copper with Al heads.
__________________
[FONT=Comic Sans MS] |
Sponsored Links (Register now to hide all advertisements) |
|
09-02-2010, 09:01 PM | #3 |
Member
Join Date: May 2010
Location: Colorado Springs, CO
Posts: 33
|
Re: 60hp head gasket
I have 2 race engines, both with aluminum heads, I have run composite (dry) for 16 years w/ no failures. Torque the alum heads 32-36 ( I "click" at 35#).
Good luck. OlRacer66 |
09-02-2010, 09:13 PM | #4 |
Member
Join Date: May 2010
Location: Preston,ct
Posts: 76
|
Re: 60hp head gasket
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|