Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 08-06-2020, 12:25 PM   #1
dmaxweb
Senior Member
 
dmaxweb's Avatar
 
Join Date: May 2010
Location: Williamsburg, VA
Posts: 485
Default Copper Manifold Gasket Orientation.

I'm installing 2 piece copper manifold gaskets. I've done this a number of times but it never occurred to me if it matters which side goes against the block. One side is formed slightly different than the other. Does it matter?
dmaxweb is offline   Reply With Quote
Old 08-06-2020, 02:08 PM   #2
Russ/40
Senior Member
 
Russ/40's Avatar
 
Join Date: May 2010
Location: Santee, California
Posts: 3,449
Default Re: Copper Manifold Gasket Orientation.

Sponsored Links (Register now to hide all advertisements)
The conventional wisdom is the same as head gaskets. The uninterupted surface goes against the block.
Russ/40 is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:08 PM.