|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-18-2022, 11:17 PM | #1 |
Member
Join Date: Jan 2017
Location: Nebraska
Posts: 49
|
How to mount 1955 side kick panels
Working to install front seat side cowl kick panels from an upholstery kit in our 1955 Crown Victoria.
Can anyone tell me how yours are secured in place in your ‘55-‘56 Ford? I see no clips other than for holding the wind lace. I see no screw holes in the side under the left and right cowl kick panel areas that would seem to work. I don’t have any original panels to look at. |
01-19-2022, 10:45 AM | #2 |
Senior Member
Join Date: May 2010
Location: Lancaster, CA
Posts: 917
|
Re: How to mount 1955 side kick panels
If you have some time, visit my website. Here is a good blog post I wrote (with photos, etc) concerning the installation of the kick panels on my 1955 Ford Club Sedan.
https://www.hotrodreverend.com/post/...-dash-lighting Each side has a slim piece of sheet metal (I call it J channel because of its shape) that attaches to the body with clips. The rear of the kick panel board slides into a groove/channel on that piece of thin metal.
__________________
Lancaster, California Visit hotrodreverend.com to view hundreds of pictures and videos of the build of the 1955 Ford Club Sedan! |
Sponsored Links (Register now to hide all advertisements) |
|
01-19-2022, 07:05 PM | #3 |
Member
Join Date: Jan 2017
Location: Nebraska
Posts: 49
|
Re: How to mount 1955 side kick panels
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|