|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-19-2016, 05:53 PM | #1 |
Senior Member
Join Date: May 2010
Location: Minnesota
Posts: 1,813
|
'35 door top weatherstrip installation
Tried to install the door top weatherstrip on my '35 3W yesterday. I lubed the strip and channel with straight dish soap; but was only able to get it pulled in
about a 1/3 of the way before it stopped. I also tried sticking the outer edge in and then tucking the inner edge in; but that does not work. The channel is smooth and clean as well as straight. What is the secret to getting the strip installed in the channel? The rubber strip is from Bob Drake. |
01-19-2016, 08:42 PM | #2 |
Member
Join Date: Jun 2011
Location: Sydney - Australia
Posts: 87
|
Re: '35 door top weatherstrip installation
Sponsored Links (Register now to hide all advertisements)
I had my good wife pushing the rubber while I was spraying and pulling ,making sure it was going in properly. It took a few goes and took some time, and my hands were aching after, but we got it done. Good Luck Pete from OZ |
Sponsored Links (Register now to hide all advertisements) |
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|