02-20-2020, 06:56 AM | #1 |
Junior Member
Join Date: Jan 2012
Location: Queensland,Australia
Posts: 10
|
Rear hub bolts
I need to replace the rear hub bolts on the A. I have steel brake drums so the new bolts require machining as they are made to suite cast iron drums. According to Mac's website the shoulder must be reduced by 1/16 inch.
Questions arising:- (refer to attached photos) 1) Is the taper between points A and B an integral factor in the swedging process? 2) Does the taper need to be maintained or can the shoulder be squared-off? 3) If it can be squared-off, from which point is the 1/16" reduction measured? 4) Has anyone worked with a dimension (C) that the shoulder needs to be from the drum pre the swedging process? Thanks in anticipation of your responses. CT |
|
|
Sponsored Links (Register now to hide all advertisements) |
|