|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
11-10-2015, 06:02 PM
|
#1 |
|
Senior Member
Join Date: Feb 2014
Location: clear lake, iowa
Posts: 157
|
what is considered big bore?
59a block back from machine shop bored .080 over. which head gaskets to use, standard or big bore?
|
|
|
|
11-10-2015, 06:56 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Oshkosh, Wi
Posts: 4,524
|
Re: what is considered big bore?
I think you are right at the limit for std bore gasket. I would go big bore.
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
11-10-2015, 10:06 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: Wa.
Posts: 5,403
|
Re: what is considered big bore?
All gaskets are not the same, even the same brand with the same part number on them.
Get a couple samples of std. and big bore and check them on the cylinder bank you intend to use it on. Check where the fire ring sits on both the block and the head. If it is not clamped between the head and block when installed, it will fail. There should be NO hangover at any point. |
|
|
|
|
11-11-2015, 09:17 AM
|
#4 |
|
Senior Member
Join Date: May 2010
Location: Above the gnat line in Georgia
Posts: 7,009
|
Re: what is considered big bore?
Hillary??
__________________
Life is like a roll of toilet paper. The closer to the end, the faster it goes. It is better to be seen, than viewed. "We sleep safe in our beds because rough men stand ready in the night to visit violence on those who would do us harm". |
|
|
|
|
11-11-2015, 10:18 AM
|
#5 | |
|
Senior Member
Join Date: May 2010
Location: Huntsville Al
Posts: 1,526
|
Re: what is considered big bore?
Sponsored Links (Register now to hide all advertisements)
Quote:
__________________
Matt 24:36-41 |
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 11:04 PM.