|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-24-2021, 06:48 PM | #1 |
Senior Member
Join Date: May 2010
Location: Mill Valley,CA
Posts: 274
|
3-brush gen problems
The three brush generator on my '36 pickup recently stopped charging, it was rebuilt about 8-9,000 miles ago and has been controlled by a FunProjects voltage regulator (the one in a cutout case); this setup worked perfectly until now. The fan belt is properly adjusted. The 3rd brush was set to give about 1-2 amps charge when driving. I disconnected the B+ and armature wires from the regulator, connected them together and it shows about 10-12 amps charge (on the dashboard ammeter) when running above idle, so I'm guessing the generator is OK and the voltage reg is at fault. As best as I can tell, FunProjects is no longer in business and so I don't think a replacement would be available. I can go back to using a standard cutout but I'm wondering if there other options?
Thanks, Adam
__________________
1936 pickup, stock, black 1965 Mustang coupe 289/4bbl, black/red 1971 Alfa Romeo GTV 1750 coupe, dark red/tan 1970 911E 2.2 litre dark blue/black 1968 BMW R50/2 US, black (m'cycle) 1967 Triumph TR6R , sea foam/cream (m'cycle) 2022 Royal Enfield Interceptor 650 red (m'cycle) 1974 Honda CB750 red (m'cycle) 2000 Kawasaki W650 blue/silver (m'cycle) |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|