|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-26-2011, 01:03 AM | #21 |
Junior Member
Join Date: Feb 2011
Posts: 16
|
Re: What parts to swap brakes to 2pot master cylinder??
I havent had a chance to crawl around on it yet. I have a side business making old west leather gear, and have a vending thing next week I have been getting ready for. Hopefully after the 4th of July, I will get a chance to get it on the hoist and see whats up.
Is that cable connected like a choke cable is? I wonder if it has just come loose under there... 63.5 |
06-26-2011, 08:25 AM | #22 |
Senior Member
Join Date: May 2010
Location: Star, MS
Posts: 4,024
|
Re: What parts to swap brakes to 2pot master cylinder??
Yes, it connects similar to a choke.
|
Sponsored Links (Register now to hide all advertisements) |
|
10-12-2011, 08:37 AM | #23 |
Junior Member
Join Date: Oct 2011
Posts: 1
|
Re: What parts to swap brakes to 2pot master cylinder??
Draggin up an old one here guys but this one is full of good info so hope no one minds.
I have a 56 2dr post car im working on. I got the 68 mustang dual pot master cylinder listed here. My car is 60 miles away(for now) so i need to get my ducks in a row before I go each time to wrench. My question: I think i get the install but to better understand...What does the original set up look like? One pot master leading to a block with 4 distribution ports? One pot master leading to two bocks to feed front and rear? So with this new set up i can basically run two lines(one from each port of the master) to a T fitting to run each wheel? |
|
|
Sponsored Links (Register now to hide all advertisements) |
|