|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-15-2019, 09:19 PM | #1 |
Member
Join Date: Mar 2017
Location: Alberta Canada
Posts: 93
|
50 shoebox diff
Can someone confirm that the pinion setting is set by crush washer or is it set by shims in this diff. Thanks for the help.
|
10-16-2019, 07:50 AM | #2 |
Senior Member
Join Date: May 2010
Location: Auburn, MA
Posts: 2,106
|
Re: 50 shoebox diff
Sponsored Links (Register now to hide all advertisements)
if you're replacing a seal just mark the nut to the shaft for reference, If you did not do that then just tighten it and check bearing preload, which I usually do bt feel. Not loose but just some drag.
__________________
“The technique of infamy is to start two lies at once and get people arguing heatedly over which is true.” ~ Ezra Pound |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|