H/F vibrator, heads up.

[quickchange]

Just a wee plug for H/F , Bought their large vibrator cleaner a couple of years ago , Its a magic way of cleaning small stuff. Add water , bit of detergent , put all your rusty bits in , nuts & bolts, etc , set it going for couple of days & they come out like new, a quick rinse & spay with wd40 . you can inspect which parts are good & which are junk, The detergent cleans the grease off too. Try it you won,t be disappointed.

[Synchro909]

I'd have bought lots of stuff from the US over the years but they are only 110 volts.

[Beauford]

On another note to rust....try Krud Kutter "A must for rust" gel. Amazing what it can do and be painted over after drying without rinsing first.

[quickchange]

Synchro909, Yes 11o v, but if two phase like my plasma cutter its 220 volt , just change the plug, Interesting on 110v I run a large tranny works good, Also work safety have no derestriction on 110 v here, so no electrical inspection on gear , cords etc, I can tell them to fly off, 4.5 angle grinders paid $9 etc Paul got a power hacksaw about $150 ,$650 kiwi $$$ was up

[Chuck Sea/Tac]

110 is one phase to grd and two phase is two hots, each one 110 to grd. So changing the 110 plug will just burn it up.

[quickchange]

Sponsored Links (Register now to hide all advertisements)

Chuck change it too a kiwi plug 220volts, works fine , that's a3 pin plug phase neutral & earth,

[SeaSlugs]

I have hf larger sonic cleaner, works wonders! Fill with 50/50 of simple green, turn the heat on, turn the sonic portion on for 5 minutes and grease/ oil just comes off. Rinse it hot water and easy paintable surface again.