|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-15-2011, 09:19 PM | #1 |
Member
Join Date: May 2010
Location: Somers Connecticut
Posts: 46
|
Windlace Removal / Install
Good evening,
Help needed please with the removal, and future installation, of windlace. The section in question is on the upper half of the hinge side of the doors on my '30 coupe. This strip of windlace runs the entire height of the door. The lower part is sewn to the covering on the door panel. The upper half is in a channel formed by the steel edge of the door being bent 180 degrees, with the opening (slot) facing the jamb when the door is closed. When I try to pull it out the windlace tears, leaving the flat (tab?) section in the slot. I could did out the torn off part with a hacksaw blade I suppose, but how does the replacement get installed? Is it glued into the slot? Thanks, Mike |
09-15-2011, 10:11 PM | #2 |
Senior Member
Join Date: May 2010
Posts: 3,099
|
Re: Windlace Removal / Install
Sponsored Links (Register now to hide all advertisements)
__________________
http://www.abarnyard.com/ |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|